User's Manual
Table Of Contents
- Important Notice
- Programming Guide
- Connecting to a Host
- System Function Settings
- Scan Mode
- Radio Communication Setting
- Operation Function Setting
- Interface Settings
- The Symbologies
- Codabar Parameter Setting
- Code 39 Parameter Setting
- Code 93 Parameter Setting
- Code 128 Parameter Setting
- Chinese Post Code Parameter Setting
- MSI/Plessy Parameter Setting
- Code 11 Interface Setting
- ITF 2 of 5 Parameter Setting
- Standard 2 of 5 Parameter Setting
- Industrial 2 of 5 Parameter Setting
- UPC/EAN/JAN Parameter Setting
- Telepen Parameter Setting
- Matrix 2 of 5 Parameter Setting
- Data Editing
- Appendix 1: USB Virtual COM Driver Installation
- Appendix 2: Barcode Length Setting
USER’S MANUAL
Di Bar Watch
5
Programming Guide
Program Procedure Using Barcode Manual
1. Power up the scanner.
2. Scan the Start of Configuration barcode.
3. Scan the barcode for the desired feature. Multiple features can be
enabled/disabled before scanning the End of Configuration barcode.
4. Scan the End of Configuration barcode and save the new configuration. Power
off and on the scanner when the setting is done.
5. To give up a configuration change, power off the scanner before scanning the
End of Configuration barcode or scan the Abort barcode.
6. For some parameter setting, such as barcode length and identifier code, it is
required to scan the Set barcode to save the configuration.
Sc
an barcode of the
desired feature
Discard the configuration
Finish the configuration
Power off the scannerScan the “Abort”barcode Scan the “End of
Configuration” barcode
Scan the “Start of
Configuration” barcode
Power up the scanner