User's Manual
Table Of Contents
- Important Notice
- Programming Guide
- Connecting to a Host
- System Function Settings
- Scan Mode
- Radio Communication Setting
- Operation Function Setting
- Interface Settings
- The Symbologies
- Codabar Parameter Setting
- Code 39 Parameter Setting
- Code 93 Parameter Setting
- Code 128 Parameter Setting
- Chinese Post Code Parameter Setting
- MSI/Plessy Parameter Setting
- Code 11 Interface Setting
- ITF 2 of 5 Parameter Setting
- Standard 2 of 5 Parameter Setting
- Industrial 2 of 5 Parameter Setting
- UPC/EAN/JAN Parameter Setting
- Telepen Parameter Setting
- Matrix 2 of 5 Parameter Setting
- Data Editing
- Appendix 1: USB Virtual COM Driver Installation
- Appendix 2: Barcode Length Setting
Di Bar Watch
6
USER’S MANUAL
Default Parameters
The factory default setting table gives the default settings of all the programmable
parameters. The default settings will be restored whenever the "Reset" programming
label is scanned and the scanner is in programming mode. Default values are highlighted
in grey background in the settings.
Factory Default Setting
Parameter Default
Radio communication
Wireless host Dongle
Pairing mode Unlocked
Data transmit Normal
Radio protocol timeout 5 seconds
Power off timeout 20 minutes
Encryption Enable
Dongle Host
RS-232 communication
Terminator <CR><LF>
USB Communication
Terminator Enter
Code mode Scan code
Keyboard US keyboard
Pair contact on dongle Enable
Scanner
Decoder Selection Default
EAN/UPC Enable
CODE 39 Enable
Code 32 Disable
CODABAR Enable
ITF 2 OF 5 Enable
MSI Disable
Chinese post code Disable
Code 93 Enable
Code 128 Enable
EAN-128 Disable
Telepen Disable
Code 11 Disable