User's Manual

USER’S MANUAL
Di Bar Watch
10
Start Of Configuration
Dongle Host Mode
The scanner communicates with the host through the dongle. Typically, scanner and
dongle in the same delivery box are paired and corresponded to host interface in factory.
To check if the scanner is paired to the dongle, check the scanner LED for slow blue flash
and check the top dongle LED for steady blue light. If scanner LED and dongle LED are
both flashing blue, follow the steps below to radio connect the scanner and dongle.
Dongle Host Pairing
1. Please make sure the scanner LED is flashing blue indicating it’s not linked to
any host. If the LED shows steady blue, the scanner is already paired to
another scanner so you must unpair the scanner before continuing.
2. Power on the scanner and enable dongle host mode if necessary.
Dongle Host mode enable
Enable dongle mode with this setting
3. Use the scanner to scan the pairing barcode at the bottom of the dongle to
begin pairing. 3 short beeps will be heard.
4. The LED indicator on the scanner will flash blue rapidly indicating search
mode in process. The LED on the dongle becomes steady blue when the
pairing is successful.
5. Scan the corresponding host interface the dongle is using to begin using the
scanner.
Return to USB default
Return to dongle USB communication.
(Communication dongle link required)
Return to Virtual COM
Port default
Return to Virtual COM Port setting
End Of Configuration