User's Manual
Table Of Contents
- Important Notice
- Programming Guide
- Connecting to a Host
- System Function Settings
- Scan Mode
- Radio Communication Setting
- Operation Function Setting
- Interface Settings
- The Symbologies
- Codabar Parameter Setting
- Code 39 Parameter Setting
- Code 93 Parameter Setting
- Code 128 Parameter Setting
- Chinese Post Code Parameter Setting
- MSI/Plessy Parameter Setting
- Code 11 Interface Setting
- ITF 2 of 5 Parameter Setting
- Standard 2 of 5 Parameter Setting
- Industrial 2 of 5 Parameter Setting
- UPC/EAN/JAN Parameter Setting
- Telepen Parameter Setting
- Matrix 2 of 5 Parameter Setting
- Data Editing
- Appendix 1: USB Virtual COM Driver Installation
- Appendix 2: Barcode Length Setting
USER’S MANUAL
Di Bar Watch
67
Start Of Configuration
Data Editing
Value
Label Description
Identifier Code
Barcode
Barcode
IS00 Disable identifier code
IS01
Enable identifier code table as factory standard
IS03
Enable identifier code table as AIM standard.
CI01
Code 39 identifier code setting
CI02
ITF 2 of 5 identifier code setting
CI03
Chinese Post Code identifier code setting
CI04
UPC-E identifier code setting
CI05
UPC-A identifier code setting
CI06
EAN-13 identifier code setting
CI07
EAN-8 identifier code setting
SET
Confirm to save this setting (required for reading full
ASCII table and length setting)
End f C O onfiguration