User's Manual

USER’S MANUAL
Di Bar Watch
76
Appendix 2: Barcode Length Setting
Introduction
The length of a barcode is the number of characters it contains, including check digits.
length. You may change the setting by the following procedure.
To set up barcode length, the paramours to be determined are barcode type and the
As listed in the Default Parameters section, each barcode type has different default
desired barcode length. Barcode length is consisted of 2 digits. For numbers smaller
than 10, you need to add a “0” in the front.
Example
If the barcode length is 4 to 12 digits, the steps would be as below:
Start Set up barcode length End
Set up minimum Set up maximum
Start of Configuration End of Configuration
barcode length barcode length
Scan the “Start of
config ation” barcode
Scan the “Se
t”
barcode to save this
settin
Scan the
“Min“ bar
code
Set the “Max”
bar
code
ur
g
Use the ASCII table (Appendix 4) to set up barcode length. Be sure to enable
the full ASCII code 39 option before you start and read the “Set” label to set
your choice into memory.
Set up the
second digit: 2
Scan the first
digit: 0
Read e “Full ASCII
co 9” barcode
Set up the first
digit: 1
Scan the “End of
co
nfiguration”
barcode
th
de 3
Turn to the page of the
barcode type to be set
u
Scan the second
digit: 4
p