User's Manual

ii
Laser Safety
The portable data terminal complies with safety
standard IEC 60825 for a Class I laser product. It
also complies with CDRH as applicable to a Class
IIa laser product. Avoid long term staring into direct
laser light.
Radiant Energy: The advanced portable data
terminal uses two low-power visible laser diodes
operating at 650nm in an opto-mechanical scanner
resulting in less than 3.9µW radiated power as
observed through a 7mm aperture and averaged
over 10 seconds.
Do not attempt to remove the protective housing of
the scanner, as unscanned laser light with a peak
output up to 0.8mW would be accessible inside.
Laser Light Viewing: The scan window is the only
aperture through which laser light may be observed
from this product. A failure of the scanner motor,
while the laser diode continues to emit a laser
beam, may cause emission levels to exceed those
for safe operation. The scanner has safeguards to
prevent this occurrence. If, however, a stationary
laser beam is emitted, the failing scanner should be
disconnected from its power source immediately.
Adjustments: Do not attempt any adjustments or
alteration of this product. Do not remove the
protective housing of the scanner. There are no