User's Manual

Cradle Host
The cradle host features with Bluetooth® wireless technology and designs
to support radio communication to the scanner. It the same has charging
functionality. Refer to Section 2.1 for battery charging instructions.
Connection on Cradle Host
The scanner pairs with the cradle, when the scanner scans barcode data
and passes to cradle via radio communication, the cradle sends data to
host by its interface cable. Steps to connect the cradle to host as follows:
1. Take the desirable interface cable and insert the RJ-45 connector to
cradle cable box until you hear a clear and short “click” sound, then
connect the other end to the host.
2. When using Keyboard wedge and USB interface for radio
communication, it is not necessary to have an external power
adapter if host has sufficient power. But these interfaces need
external power adapter when charging batteries.
Note: When external power adapter (9V) is available, the cradle will
disregard the power supply from host (5V).
3. If using RS-232 interface, it is necessary to plug an external power
adapter always. Plug the power adapter into the DC-Jack of cradle
cable box. (Shown as Figure )
4. Once cradle powers up, its LED lamp lights RED for one second then
turns to flashes BLUE light. The BLUE LED means the cradle is
waiting to be connected. If the scanner pairs with this cradle, they
are connected, and BLUE LED light is always on.
8