User`s manual

ZEBEX INDUSTRIES INC.
Pre/Postamble Function
Sometimes you want to add certain character at the beginning or end
of a barcode for identification purpose. Here you can manually enable
/ disable and specify the character you wish to add in additional to the
regular barcode content.
Fig 43 Fig 44 Fig 45
In Fig 43 press or to adjust Enable or Disable for Get Barcode Type.
After setup press Ｅ to enter into Fig 44.
In Fig 44 press or to adjust Scan Timeout Beep. After setup press
Ｅ to enter into Fig 45.
In Fig 45 Pre/Postamble setup is shown. Enter the necessary parameters
and press Ｅ to leave the screen.
Upload Menu
Unless you are using Online Scanning mode, you will need to upload the scanned
data onto a host device at some point. Here you can upload data and set the
delimiter (separator) between each field / record. The communicator use during the
upload will be same as the communication method selected in Setting >> System
Setting >> Communication >> Comm. Paramter.
Fig 46
 Press １ enter into Upload Data function.
 Press ２ enter into Delimiter Set function.

Subject Version DatePage
Z-2121 series User’s Manual 4.00 2012/7/20 43 / 50