User`s manual

ZEBEX INDUSTRIES INC.
Start to operate the Z-2121
Take out the terminal, install in a set of fully charged battery.
1. Press the “Power” key. After the display appears, press “M2”
key to enter the System Menu.
2. Then Press “1” to enter the “Run Task” menu. Then press “1”
again to execute the “FREETASK”.
3. Press “SCAN” to do barcode scanning and data collecting.
Firmware Operation Quick Start Guide
Insert battery into the Z-2121, and the display will be shown in Fig 1.
Fig 1
After display is shown in Fig 1, the vibration will shake and then show to press any
key to Fig 3 or can press
key into Fig 2.
Fig 2
In Fig 2 is asked for clean the data or not, press M2 to select Y or N, after confirmed
to press Ｅ into Fig 4

Subject Version DatePage
Z-2121 series User’s Manual 2.00 2011/4/12 22 / 49