User's Manual

148603 Project Document

148603 Specification and Integration Guide

Confidential Material – Disclosure Strictly Prohibited. "Ni ckel Leucochroic Puffin"

4. Design Guidelines and Recommendations

4.1. Typical Application Schematic

General Note: This typical application schematic and BOM has not been updated to reflect the addition of

RF0 and the associated part numbers in the Section 1.4. As such, please use the latest MPA3 platform

schematics. This section(4.1) is superseded by Section 1.4 and the MPA3 controlled schematics.

NOTE: FM is DISABLED in all revisions, and WLAN RF0 Path is not populated in

the -01 and -02 versions.

An application schematic has been created for the MPA3 platform and is controlled

outside of this document. Schematic-function-blocks have been created for each sub-

function such as optional BT and FM.

Shown on page 16 is a typical application schematic for the 148603 module with all

schematic blocks for both the -01 and -02 module versions. Listed below Table 3 is the

bill of materials (BOM) for the Application Schematic.

 IMPORTANT NOTE: SDIO lines must be pulled up by the host.

 Place signal conditioning resistor on SDIO_CLK close to host processor.