User's Manual

AP-7131 Access Point: Installation Guide

• Do not block or cover airflow to the Power Injector.

• Keep the Power Injector away from excessive heat, humidity, vibration and dust.

• The Power Injector isn’t a repeater, and does not amplify the Ethernet signal. For optimal

performance, ensure the Power Injector is placed as close as possible to the data port.

To install the Power Injector to an Ethernet data source and AP-7131:

1. Connect the Power Injector to an AC outlet (110VAC to 220VAC).

2. Connect an RJ-45 Ethernet cable between the network data supply (host) and the Power

Injector Data In connector.

3. Connect an RJ-45 Ethernet cable between the Power Injector Data & Power Out connector

and the AP-7131 GE1/POE port.

Ensure the cable length from the Ethernet source (host) to the Power Injector and AP-7131

does not exceed 100 meters (333 ft).

CAUTION Ensure AC power is supplied to the Power Injector using an AC cable

with an appropriate ground connection approved for the country of

operation.

NOTE Cabling the Power Injector to the AP-7131’s WAN port renders the

AP-7131 non-operational. Only use a AP-PSBIAS-1P3-AFR model Power

Injector with the AP-7131’s GE1/POE (LAN) port.