User's Manual

Regulatory Compliance

IMPORTANT NOTE: This module is intended for OEM integrator only and limited to host with brand: Motorola and

model: AP-7131-MB82. The OEM integrator is still responsible for the FCC compliance requirement of the end

product, which integrates this module. 20cm minimum distance has to be able to be maintained between the

antenna and the users for the host this module is integrated into. Under such configuration, the FCC radiation

exposure limits set forth for a population/uncontrolled environment can be satisfied. Any changes or modifications not

expressly approved by the manufacturer could void the user's authority to operate this equipment. USERS MANUAL

OF THE END PRODUCT: In the users manual of the end product, the end user has to be informed to keep at least

20cm separation with the antenna while this end product is installed and operated. The end user has to be informed

that the FCC radio-frequency exposure guidelines for an uncontrolled environment can be satisfied. The end user has

to also be informed that any changes or modifications not expressly approved by the manufacturer could void the

user's authority to operate this equipment. LABEL OF THE END PRODUCT: The final end product must be labeled

in a visible area with the following " Contains TX FCC ID: UZ7AP7131 ". The FCC part 15.19 statement below has to

also be available on the label: This device complies with Part 15 of FCC rules. Operation is subject to the following

two conditions: (1) this device may not cause harmful interference and (2) this device must accept any interference

received, including interference that may cause undesired operation.

The device could automatically discontinue transmission in case of absence of information to transmit, or

operational failure. Note that this is not intended to prohibit transmission of control or signaling information or the

use of repetitive codes where required by the technology.

The device for the band 5150-5250 MHz is only for indoor usage to reduce potential for harmful interference to co-

channel mobile satellite systems.

The maximum antenna gain permitted (for devices in the bands 5250-5350 MHz and 5470-5725 MHz) to comply

with the e.i.r.p. limit.

The maximum antenna gain permitted (for devices in the band 5725-5825 MHz) to comply with the e.i.r.p. limits

specified for point-to-point and non point-to-point operation as appropriate, as stated in section A9.2(3).

High-power radars are allocated as primary users (meaning they have priority) of the bands 5250-5350 MHz and

5650-5850 MHz and these radars could cause interference and/or damage to LE-LAN devices.

IMPORTANT NOTE: This module is intended for OEM integrator only and limited to host with brand: Motorola and

model: UZ7AP7131. The OEM integrator is still responsible for the IC compliance requirement of the end product, which

integrates this module. 20cm minimum distance has to be able to be maintained between the antenna and the users for

the host this module is integrated into. Under such configuration, the IC RSS-102 radiation exposure limits set forth for a

population/uncontrolled environment can be satisfied. Any changes or modifications not expressly approved by the

manufacturer could void the user's authority to operate this equipment. USERS MANUAL OF THE END PRODUCT: In

the users manual of the end product, the end user has to be informed to keep at least 20cm separation with the antenna

while this end product is installed and operated. The end user has to be informed that the IC radio-frequency exposure

guidelines for an uncontrolled environment can be satisfied. The end user has to also be informed that any changes or

modifications not expressly approved by the manufacturer could void the user's authority to operate this equipment. IC

statement is required to be available in the users manual: This Class B digital apparatus complies with Canadian

ICES-003. Operation is subject to the following two conditions: (1) this device may not cause harmful interference and (2)

this device must accept any interference received, including interference that may cause undesired operation. LABEL

OF THE END PRODUCT: The final end product must be labeled in a visible area with the following " Contains TX IC:

109AN–AP7131 ".