User's Manual
Table Of Contents
- 1 Introduction
- 2 Hardware Installation
- 3 Basic Access Point Configuration
- 4 Specifications
- 5 Regulatory Information
- 5.1 Regulatory Overview
- 5.2 Wireless Device Country Approvals
- 5.3 Health and Safety Recommendations
- 5.4 RF Exposure Guidelines
- 5.5 Power Supply
- 5.6 Wireless Devices - Countries
- 5.7 Radio Frequency Interference Requirements—FCC
- 5.8 Radio Frequency Interference Requirements – Canada
- 5.9 CE Marking and European Economic Area (EEA)
- 5.10 Waste Electrical and Electronic Equipment (WEEE)
- 5.11 TURKISH WEEE Statement of Compliance
- 6 Motorola Solutions Support Center
- 7 AP7131 Series ROHS Compliance
Installation Guide 27
5. Click the Login button to load the management interface.
6. If this is the first time the management interface has been accessed, a dialogue displays allowing an
administrator to define whether a ty[ical setup or advancd setup is conducted.
For the purposes of this guide, use the Typical Setup (Recommended) option to simply the process of
getting the Access Point up and running quickly with a minimum number of changes to the Access Point’s
default configuration.
For information on using the Access Point’s Advanced Setup option, refer to the WiNG Access Point
System Reference Guide to familiarize yourself with the feature set supported by the WiNG operating
system. The guide is available at
http://supportcentral.motorolasolutions.com/support/product/manuals.do
.
NOTE When logging in for the first time, you’re prompted to change the
password to enhance device security in subsequent logins.
NOTE If you get disconnected when running the wizard, you can connect again
with the Access Point’s actual IP address (once obtained) and resume the
wizard.