User's Manual
Table Of Contents
- 1 Introduction
- 2 Hardware Installation
- 3 Basic Access Point Configuration
- 4 Specifications
- 5 Regulatory Information
- 5.1 Regulatory Overview
- 5.2 Wireless Device Country Approvals
- 5.3 Health and Safety Recommendations
- 5.4 RF Exposure Guidelines
- 5.5 Power Supply
- 5.6 Wireless Devices - Countries
- 5.7 Radio Frequency Interference Requirements—FCC
- 5.8 Radio Frequency Interference Requirements – Canada
- 5.9 CE Marking and European Economic Area (EEA)
- 5.10 Waste Electrical and Electronic Equipment (WEEE)
- 5.11 TURKISH WEEE Statement of Compliance
- 6 Motorola Solutions Support Center
- 7 AP7131 Series ROHS Compliance
Installation Guide 33
16. Select Next. The Initial AP Setup Wizard displays the Summary and Commit screen to summarize the
screens (pages) and settings updated using the Initial Setup Wizard.
No user intervention or additional settings are required within this screen. Its an additional means of
validating the Access Point’s updated configuration before its deployed. However, if a screen displays
settings not intended as part of the initial configuration, then any screen can be selected again from
within the Navigation Panel and its settings modified accordingly.
17. If the configuration displays as intended, select the Save/Commit button to implement these settings to
the Access Point’s configuration. If additional changes are warranted based on the summary, either select
the target page from the Navigational Panel, or use the Back and Next buttons to scroll to the target
screen.