User's Manual

AP 7161 Access Point Installation Guide 15
When mounting antennas to connectors marked R2-A, R2-B and R2-C, these antenna ports relate to the software
settings of radio 2. Care must be taken to provide the correct antenna for the operating band of each port.
AP 7161 three radio models (AP-7161-66S40-US and AP-7161-66S40-WR) are configured with eight N type
connectors to support two active WLAN data radios and a dedicated sensor radio as the third.
As with two radio models, the rules for ports R1-A, R1-B and R1-C and R2-A, R2-B and R2-C apply. R3-A and R3-B
are the ports reserved for the sensor radio, and an appropriate multi band antenna should be mounted to the unit
for sensor operation.
NOTE The sensor radio does not function as a WLAN data radio.
WARNING! Antenna ports where no antenna is mounted must be properly terminated using an
approved IP67 terminator.