User's Manual

AP 7161 Access Point Installation Guide 27
4. Insert two M6 hex flange screws into the bottom holes on the sides of the access point bracket section.
5. With the access point positioned so that the gore vent is facing down, insert the two M6 hex flange screws in
the bottom holes on the sides of the access point bracket section into the open slot connections on the bottom
of the angle adapter bracket section.
6. Rotate the access point bracket section upward and align the top holes on the sides with the top holes on the
angle adapter bracket section. Insert two M6 hex flange screws into the top holes on the angle adapter bracket
section.
7. Use a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, to finish attaching the access
point bracket section to the angle adapter bracket section with the M6 hex flange screws in the open slot
connections and the top holes on the angle adapter bracket section. Do not tighten the screws until all rotation
and tilt adjustments are complete.
8. To adjust the position of the access point, rotate the access point bracket section (plus or minus 15 degrees)
and tilt the angle adapter bracket section (up to 45 degrees).
9. Tighten all hex flange screws to 60 inch pounds (lbf-in).
To use the extension arm with the mounting hardware kit :
1. Attach the pole mount section at the desired mounting location using a U-bolt or band clamps.
2. Complete the steps for assembling and positioning the mounting bracket sections for poles less than or greater
than 3 inches outlined above.
3. Using a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, attach the extension arm to
the access point bracket section with four M6 hex flange screws. Tighten the hex flange screws to 60 inch
pounds (lbf-in).
4. With the access point positioned so that the gore vent is facing down, attach the extension arm to the access
point with four M6 hex flange screws. Tighten the hex flange screws to 60 inch pounds (lbf-in).