User's Manual

18 AP-7622 Access Point

If Startup Assist does not automatically display, it can be invoked at any time from

the upper-left of the Basic Configuration screen.

6. Set the following Startup Assist parameters:

• Virtual Controller - Select this option to set this Access Point as a Virtual

Controller capable of managing and provisioning up to 64 Access Points of the

same model. Those Access Points managed by this Virtual Controller list this

Note • Startup Assist automatically sets the radio transmit power and enables

Auto Channel selection. The Access Point's name is automatically assigned

based on the Access Point type and the last three octets of the device's

hardcoded MAC address. WLAN 1 and WLAN 2 both use VLAN ID 2200 by

default. To adjust any of these parameters, edit the appropriate configuration

screen directly. Refer to the Access Point reference material available on

Zebra Support for configuring the Access Point beyond the scope of the

minimal WiNG Assist configuration described in this guide. For more

information, go to