User's Manual

Installation Guide 15
2.6 Suspended Ceiling T-Bar Mount Instructions
Ceiling mount requires holding the AP-8432 up against the T-bar of a
suspended ceiling grid and twisting the unit on to the T-bar. If deploying the
AP-8432 on a sculpted ceiling T-Bar, the Access Point mounting kit (Part No.
KT-135628-01) can optionally be used as well.
1. Install the mounting bracket on the T-bar, then attach the mounting
bracket using the mounting slots on the Access Point.
2. Cable the Access Point using either the Power Injector solution
(AP-PSBIAS-2P3-ATR) or the approved AP-8432 power supply
(PWR-BGA48V45W0WW).
For Power Injector installations:
a. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the
network data supply (host) and the Power Injector Data In
connector.
b. Connect a RJ-45 CAT5e (or CAT6) Ethernet cable between the
Power Injector Data & Power Out connector and the Access Point’s
GE1/POE port.
c. Ensure the cable length from the Ethernet source (host) to the
Power Injector and Access Point does not exceed 100 meters
(333 ft). The Power Injector has no On/Off power switch. The Power
Injector receives power as soon as AC power is applied.
AP8432_IG.book Page 15 Monday, March 14, 2016 8:39 AM