User's Manual

16 AP-8432 Access Point
For standard power adapter (non Power Injector) and line cord
installations:
a. Connect a RJ-45 Ethernet cable between the network data supply
(host) and the Access Point’s GE1/POE port.
b. Verify the power adapter is correctly rated according the country of
operation.
c. Connect the power supply line cord to the power adapter.
d. Attach the power adapter cable into the power connector on the
Access Point.
e. Attach the power supply line cord to a power supply.
3. Verify the unit has power by observing the LEDs. For more information
on AP-8432 LED behavior, see LED Indicators on page 18.
4. Align the bottom of the ceiling T-bar with the back of the Access Point.
5. Orient the Access Point chassis by its length and the length of the
ceiling T-bar.
6. Rotate the Access Point chassis 45 degrees clockwise.
7. Push the back of the Access Point chassis on to the bottom of the
ceiling T-bar.
Caution • If not using an AP-PSBIAS-2P3-ATR Power Injector, ensure
only the AP-8432’s designated power supply
(PWR-BGA48V45W0WW) is used to supply power to the Access
Point. Using an incorrectly rated power supply could damage the
Access Point and void the product warranty. Do not actually connect
to the power source until the cabling portion of the installation is
complete.
AP8432_IG.book Page 16 Monday, March 14, 2016 8:39 AM