ET5X Enterprise Tablet Quick Reference Guide
Tablet ET5X Enterprise Zebra reserves the right to make changes to any product to improve reliability, function, or design. Zebra does not assume any product liability arising out of, or in connection with, the application or use of any product, circuit, or application described herein.
Quick Reference Guide Introduction The ET5X are Windows® and Android™ based tablets that come in 8” and 10” configurations. • ET50: WLAN only • ET55: WLAN and WWAN. Features NOTE Windows button only available on Windows tablets. 1 1 2 3 4 2 3 4 5 10” Android Version 8” Windows Version Item 6 - Windows only Description 1 Ambient Light Sensor - Recognizes the ambient light and adjusts the display brightness (if enabled). 2 Front Microphone - Use for voice communications.
Tablet ET5X Enterprise Item Description 4 Camera Indicator LED - Lights red when the camera is activate. Momentarily lights red when the device boots and shuts down. 5 Charging Indicator LED - Indicates charging status. • OFF - device is not connected to charger. • ORANGE - device is charging. • GREEN - device is connected and fully charged. • RED - charge error. 6 Windows Button - Press to launch the Windows Home screen (Windows Tablets only).
Quick Reference Guide Item Description 14 Micro USB Interface (charging only) - Provides for charging the ET5X using USB cable and power supply. On Android devices, provides communication with host computer. 15 USB 2.0 Port - Provides input for USB devices. 16 Back Cover - Covers the service replaceable battery. 8” Version 18 17 18 19 18 Item Description 17 NFC Antenna Position - Use to read NFC cards and RFID tags. 18 Stereo Speakers - Provides audio playback.
Tablet ET5X Enterprise 3. Carefully lift the battery cover off the ET55. 4. On the 8” version, push the two locking tabs up, then pull up on the tab to remove battery. On the 10” version, push the two locking tabs up (1), then, using index fingers, lift the battery up (2). Pull Tab Locking Tabs 8” Version Locking Tabs 10” Version 5. Insert the micro SIM card with contacts facing down. CAUTION Do not use nano to micro SIM card adapters. Only use micro SIM cards.
Quick Reference Guide 8” Version 10” Version 6. Push the micro SIM card in and ensure that it locks into place. 7. Replace the battery. On the 10” version, ensure that the two battery latches engage. CAUTION Be aware of the orientation of the battery cover. Failure to replace the battery cover properly may damage the battery cover. 8. Align the tabs on the underside of the cover with the slot around the battery well.
Tablet ET5X Enterprise 9. Carefully press down around the edge of the cover. Make sure that the cover is seated properly. 10. Press Power button to turn on the ET55. Install a micro SD Card To install a microSD card: 1. Open access door. 2. Insert microSD card into slot with contacts facing down. 3. Press the card in to ensure that it is seated properly. 4. Close access door.
Quick Reference Guide NOTE The Charge Only Cradle (CRD-ET5X-1SCG1) and the Communication and Charge Cradle (CRD-ET5X-1SCOM1) come with two inserts; tall insert and short insert. Install the tall insert when using an ET5X without a Rugged Frame and Expansion Back. Install the small insert when using an ET5X with an Expansion Back and without a Rugged Frame. Do not install either insert when using the ET5X with the Rugged Frame.
Tablet ET5X Enterprise Cradle Insert Required Communication and Charging Cradle Cradle Insert Not Required Charge Only Cradle Cradle Insert Not Required Rugged Communication and Charging Cradle 4. The ET5X Charging LED indicates charging. 5. To remove the ET5X from the Charge Only cradle, hold the cradle down with one hand and lift the ET5X.
Quick Reference Guide 1 To remove the ET5X from either Communication Cradle, press the release button on the right side of the cradle and lift the ET5X. Use thumb to hold down the cradle. Using the Camera To take photos or videos: 1. Open the Camera application. The Camera Indicator LED lights red. 2. Point the ET5X camera at an object. 3. Touch the on-screen shutter button to take a photo or record a video. Reading NFC Cards And RFID Tags The ET5X supports reading NFC cards and RFID tags.
Tablet ET5X Enterprise With an NFC enabled application open, bring the NFC card toward the antenna. Depending upon the application, an audio or visual indication indicates successful reading of the card. NFC Antenna Location Regulatory Information This device is approved under Zebra Technologies Corporation. This guide applies to the following Model Numbers: ET50NE, ET50NT, ET50PE, ET50PT, ET55AE, ET55AT, ET55BE, ET55BT, ET55RE, ET55RT, ET55TE and ET55TT.
Quick Reference Guide 1 • • ET55Ax and ET55Bx: Radio card, Type(s): EM7355: Sierra Wireless PCI Express (LTE, HSPA+. GSM/GPRS/EDGE, CDMA) ET55Rx and ET55Tx: Radio card, Type(s): ME936: Huawei Wireless module (LTE, HSPA+. GSM/GPRS/EDGE) Bluetooth® Wireless Technology This is an approved Bluetooth product. For more information or to view the End Product Listing, please visit http://www.bluetooth.org/tpg/listings.cfm.
Tablet ET5X Enterprise AVERTISSEMENT Le dispositive fonctionnant dans la bande 5150-5250 MHz est réservé uniquement pour une utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux. Les utilisateurs de radars de haute puissance sont désignés utilisateurs principaux (c.-à-d.
Quick Reference Guide 1 Pacemakers Pacemaker manufacturers recommended that a minimum of 15 cm (6 inches) be maintained between a handheld wireless device and a pacemaker to avoid potential interference with the pacemaker. These recommendations are consistent with independent research and recommendations by Wireless Technology Research. Persons with pacemakers: • • • • Should ALWAYS keep the device more than 15cm (6 inches) from their pacemaker when turned ON.
Tablet ET5X Enterprise and similar accessories may not comply with FCC RF exposure compliance requirements, and should be avoided. To satisfy US and Canadian RF exposure requirements, a transmitting device must operate with a minimum separation distance of 5 mm or more from a person's body.
Quick Reference Guide 1 one year or longer, the charge level should be verified at least once a year and charged to half of full charge. Replace the battery when a significant loss of run time is detected. Standard warranty period for all Zebra batteries is one year, regardless if the battery was purchased separately or included as part of the mobile computer or bar code scanner. For more information on Zebra batteries, please visit: http://www.zebra.com/batterybasics.
Tablet ET5X Enterprise 2. Carefully lift the battery cover off the ET5X. 3. On the 8” version, push the two locking tabs up, then pull up on the tab to remove battery. On the 10” version, push the two locking tabs up (1), then, using index fingers, lift the battery up (2).
Quick Reference Guide 2 by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: • • • • Reorient or relocate the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio/TV technician for help.
22 Tablet Statement of Compliance ET5X Enterprise Zebra hereby declares that this radio equipment is in compliance with Directive 2011/65/EU and 1999/5/EC or 2014/53/EU (2014/53/EU supersedes 1999/5/EC from 13th June 2017). The full text of the EU Declaration of Conformity is available at the following internet address: http://www.zebra.com/doc. Other Countries Australia Use of 5 GHz RLAN's in Australia is restricted in the following band 5.50 - 5.65GHz. Mexico Restrict Frequency Range to: 2.450 - 2.
Quick Reference Guide διεύθυνση http://www.zebra.com/weee στο Διαδίκτυο. Malti: Għal klijenti fl-UE: il-prodotti kollha li jkunu waslu fl-aħħar tal-ħajja ta' l-użu tagħhom, iridu jiġu rritornati għand Zebra għar-riċiklaġġ. Għal aktar tagħrif dwar kif għandek tirritorna l-prodott, jekk jogħġbok żur: http://www.zebra.com/weee. Românesc: Pentru clienţii din UE: Toate produsele, la sfârşitul duratei lor de funcţionare, trebuie returnate la Zebra pentru reciclare.
24 Tablet ET5X Enterprise Licensee may transfer such Software license, but only if: (i) Licensee transfers all copies of such Software to the U.S. Government end user or to an interim transferee, and (ii) Licensee has first obtained from the transferee (if applicable) and ultimate end user an enforceable end user license agreement containing restrictions substantially identical to the ones contained in this Agreement.
Quick Reference Guide 2 FROM ZEBRA OR ITS AFFILIATES SHALL BE DEEMED TO ALTER THIS DISCLAIMER BY ZEBRA OF WARRANTY REGARDING THE SOFTWARE, OR TO CREATE ANY WARRANTY OF ANY SORT FROM ZEBRA. 11. THIRD-PARTY APPLICATIONS. Certain third party applications may be included with, or downloaded with this Software. Zebra makes no representations whatsoever about any of these applications. Since Zebra has no control over such applications, you acknowledge and agree that Zebra is not responsible for such applications.
CMM Disclosure 有害物质 部件名称 (Parts) 金属部件 (Metal Parts) 电路模块 (Circuit Modules) 电缆及电缆组件 (Cables and Cable Assemblies) 塑料和聚合物部件 (Plastic and Polymeric Parts) 光学和光学组件 (Optics and Optical Components) 电池 (Batteries) 铅 (Pb) 汞 (Hg) 镉 (Cd) 六价铬 (Cr(VI)) 多溴联苯 (PBB) 多溴二苯醚 (PBDE) X O X O O O X O O O O O O O O O O O O O O O O O O O O O O O X O O O O O 本表格依据SJ/T 11364 的规定编制。 O: X: 表示该有害物质在该部件所有均质材料中的含量均在 GB/T 26572 规定的限量要求以下。 表示该有害物质至少在该部件的某一均质材料中的含量超出 GB/T 26572 规定的限量要求。( 企业