User Guide
Table Of Contents
- Warranty
- Revision History
- About This Guide
- Quick Start
- Getting Started
- Installation and Communication
- Administrator Console
- Introduction
- Connecting to the Reader
- Administrator Console Login
- Reader Administrator Console
- Status
- Reader Statistics
- Configure Reader
- Read Tags
- Communication Settings
- System Time Management
- IPV6 IP Sec
- Change Password
- GPIO
- Applications
- Reader Profiles
- Firmware Version/Update
- Commit/Discard
- System Log
- Reader Diagnostics
- Shutdown
- Wi-Fi Configuration
- Application Development
- Firmware Upgrade
- Troubleshooting
- Technical Specifications
- Static IP Configuration
- RF Air Link Configuration
- Connecting Wi-Fi and Bluetooth Dongles
- Copying Files To and From the Reader
- Data Protection
Administrator Console 4 - 37
Network Services Settings
Select Services to view the Configure Network Service Settings window.
Figure 4-26
Configure Network Service Settings Window
The reader supports the following network services.
•
Web Server - Configures the web server in either HTTP (unsecure) or HTTPS (secure) mode.
•
Shell - Sets the shell to SSH (secure) mode or a disabled state.
•
File Server - Sets the file server to either FTP (unsecure) or FTPS (secure) mode.
•
Disable IPV6 Stack - Select this to disable the reader's IPV6 stack.
•
Receive RA packets - This option is only valid when the IPV6 stack is enabled. Enable this to allow IPV6
IP configuration through RA packets; otherwise obtain the IP via DHCP in the Communication window or
assign statically.
NOTE You must click Commit to update the service configuration (see Save Changes.) If the Commit is not
successful, the system indicates the problem and allows correcting it by repeating the operation.
Draft 2