User Guide
Table Of Contents
- Warranty
- Revision History
- About This Guide
- Quick Start
- Getting Started
- Installation and Communication
- Administrator Console
- Introduction
- Connecting to the Reader
- Administrator Console Login
- Reader Administrator Console
- Status
- Reader Statistics
- Configure Reader
- Read Tags
- Communication Settings
- System Time Management
- IPV6 IP Sec
- Change Password
- GPIO
- Applications
- Reader Profiles
- Firmware Version/Update
- Commit/Discard
- System Log
- Reader Diagnostics
- Shutdown
- Wi-Fi Configuration
- Application Development
- Firmware Upgrade
- Troubleshooting
- Technical Specifications
- Static IP Configuration
- RF Air Link Configuration
- Connecting Wi-Fi and Bluetooth Dongles
- Copying Files To and From the Reader
- Data Protection
5 - 4 FX7500 RFID Reader Integrator Guide
Preferred Configurations for Access Points
The FX7500 reader supports WPA/WPA2 (http://en.wikipedia.org/wiki/Wi-Fi_Protected_Access) and also
WEP128 (http://en.wikipedia.org/wiki/Wired_Equivalent_Privacy) by default over the Administrator Console.
Other supported protocols are explained in previous sections. This section provides details on the preferred
configurations for access points.
AP: Zebra AP 5131
Network Type: WPA/TKIP
Figure 5-2
AP 5131, WPA/TKIP
Create a security policy WPA and select WPA/TKIP from the Encryption menu. Enter an ASCII password
between 8 and 63 characters or 64 hex characters. Select Apply and associate the ESSID with a security
policy.
Draft 2