User's Manual

Setup and Deployment

Detailed instructions can be found in the WMC6300 User’s Guide for each operating system.

In addition, the

Administration Software and Documentation CD includes installation

software to load the MeshView Administration Tool. MeshView may be installed as an option on

a subscriber device to assist the Network Operator with network deployment. Refer to the

MeshView Administration Tool User’s Guide for additional information on this application.

Installing the WMC6300 Software for Windows 2000

The WMC6300 Wireless Modem Card User’s Guide for Windows 2000 provides complete

step-by-step instructions for use during the installation and configuration of the WMC6300. The

following is an abbreviated version of the installation process.

Note: Please install the

Software before you insert the WMC6300 card.

Complete the following procedure to install the WMC6300 software and drivers:

1. Insert the

Software and Documentation CD into the computer’s CD-ROM drive.

2. The

Setup program will be displayed.

Note: If the installation program does not start automatically, open the Windows Start

menu, click on Run, and then type d:setup.exe (where d is the letter of the CD-ROM

drive) and click the “OK” button.

3. Click the “Next” button to continue the software installation process.

4. Follow the onscreen prompts to complete the installation process.

5. Insert the antenna into the WMC6300 card.

6. Insert theWMC6300 card into the PCMCIA slot of the host computer.

If MeshView is desired, insert the

Administration Software and Documentation CD, open

the Windows Start menu, click on Run, and then type d:setupmv.exe (where d is the letter of

the CD-ROM drive) and click the “OK” button. Follow onscreen prompts to complete the

installation process.

Installing the WMC6300 Software for Windows XP

The WMC6300 Wireless Modem Card User’s Guide for Windows XP provides complete

step-by-step instructions for use during the installation and configuration of the WMC6300. The

following is an abbreviated version of the installation process.

Note: Please install the

Software after you insert the WMC6300 card. .

Complete the following procedure to install the WMC6300 software and drivers:

1. Insert the antenna into the WMC6300 card.

2. Insert the WMC6300 card into the computer.

3. Click the “Cancel” button for the 2 “Found New Hardware” windows.

4. Click the “Close” button for the “Found New Hardware information” window.

5. Insert the WMC6300 Software and Documentation CD into the computer’s CD-ROM

drive.