User's Manual

Setup and Deployment
15
Network Configuration – Device Manager
“Device Manager” is a utility located on the MeshManager server. It is used to configure and
monitor the deployed network. Refer to the MeshManager User’s Guide for detailed instructions
on how to use the Device Manager.
Mea systems are delivered with the initial configuration of IAPs, WRs, and SDs in the
MeshManager system. This allows for easy testing of the system as units are tested on site.
There are two basic tests to verify correct operation the system. The first test is to perform ping
tests to each device and the second test is to verify access the Internet.
Network Configuration – IAP Configuration Via Web Interface
A second method of performing various network configuration functions for an IAP may be
accomplished using a standard web browser. Connect a host PC to the switch in the MiSC.
Using a standard Internet Browser such as Microsoft’s Internet Explorer or Netscape, enter the
IP Address corresponding to the IAP to be configured as shown in Figure 13. If you do not
know the IP address of the IAP then contact the system administrator. Optionally, if the network
has been configured with a DHCP Server and a DNS Server, you may use the Device System
Name. Since all IAPs ship with the same default Device System Name, it is recommended that
you install and configure the IAPs one at a time.
Figure 13. MEA Device Administration Connection
A Log On window for the Configuration Utility will be displayed in the browser, as shown in
Figure 14. Before the Configuration Utility is displayed, the user must complete the simple
logon procedure before proceeding. When the Log On is complete, the Configuration Utility will
be displayed. The default login is “admin’ and the password is “admin”. The password can be
changed, as described further in this document.