User's Manual

Setup and Deployment
19
Click on the “OK” button to continue or select “Cancel” to terminate the Firmware
Update procedure.
Figure 20. MEA Device Administration Update Confirmation Window
3. If the “OK” button is selected, the new Firmware is loaded into the device. The Firmware
Update window will then be displayed to indicate that the selected file was successfully
uploaded and to recommend that you reboot the device.
4. As the Firmware is being uploaded, a status page is displayed as shown in Figure 21.
Figure 21. MEA Device Administration Update Device Status Window
5. At the completion of the update, the IAP’s SBC must be reset for the update to take
effect. Select the “Home” tab and then click on the “Reset Device” button as described
in the procedure located on page 21. The device will reset and return to the “Home” tab.
Note: Do not to close the browser until the process is complete.