User's Manual

Setup and Deployment
23
• Ping an IAP
• Ping the NAT Router
• Ping the Edge Router
Wireless System Tests
From Device Manager, complete the following to verify correct operation of the system:
1. Ping the SBC of the deployed IAPs
• From the Device Manager drop down menu, select Preferences/Use SBC Address
• For each IAP in the device tree, right click and select Ping Device
2. Ping the transceiver of the deployed IAPs
• From the Device Manager drop down menu, select Preferences/Use Transceiver
Address
• For each IAP in the device tree, right click and select Ping Device
3. Ping the transceiver of the deployed WRs
• From the Device Manager drop down menu, select Preferences/Use Transceiver
Address
• For each WR in the device tree, right click and select Ping Device
4. Ping the transceiver of each Subscriber Devices
• From the Device Manager drop down menu, select Preferences/Use Transceiver
Address
• For each SD in the device tree, right click and select Ping Device
Internet Test
If the system has been configured to access the Internet, complete one of the two
following tests to verify correct network setup:
1. From a provisioned SD, start the web browser and enter a URL such as
http://www.MeshNetworks.com
.
2. From a SD, open a DOS/cmd window and ping an URL, e.g., ping
www.meshnetworks.com.
Default Addresses and Logins
The following are the default values for the system components. These may be updated during
installation.
Device Description Default
Core Router login password
g0ld1
Core Router enable password
g0ld11
Core Router IP address on Sever
172.31.0.2