User's Manual
Table Of Contents
- FCC Radiation Exposure Statement (applicable to 15.247 device only)
- Introduction
- Controls, Connectors, and Indicators
- LCD Panel
- Installation and Setup
- General Information
- Unpacking the Printer
- Installing the Print Driver Software and Setting Driver Options
- Installing the P330i Print Driver
- Loading a Ribbon
- Installing the Card Cleaning Cartridge
- Setting the Card Thickness Control
- Loading Cards
- Card Output Hopper
- Connecting the Printer to your Computer
- Connecting Power
- Printing a Test Card
- Packing the P330i Printer for Shipment
- Printing a Card
- Setting Printer Properties
- Printing a Sample Card
- Feeding One Card at a Time
- Cleaning
- Cleaning the Printer
- When to Clean
- How to Clean
- Cleaning the Print Head
- Card Cleaning Cartridge
- When to Replace the Cleaning Roller
- How To Replace the Cleaning Roller
- Troubleshooting
- Print Quality Issues
- Troubleshooting the Ethernet Connection and Adapter
- Resetting to Factory Defaults
- Ethernet Adapter Status Indicator
- Network Status/Activity Indicator
- Technical Specifications
- General Specifications
- Ribbon Specifications
- Card Specifications
- Bar Codes
- Fonts
- Card Dimensions
- Bi-Directional Communications Interfaces
- Mechanical Specifications
- Electrical
- Environmental
- Options
- Magnetic Card Encoder
- Introduction
- Media Loading Orientation
- Sample Encoding Program
- Magnetic Encoder Cleaning
- When to Clean
- How to Clean
- ISO Standard Encoding
- Smart Card Contact Station
- Introduction
- Media Loading Orientation
- Smart Card Contact Station Interface
- Connecting to a Network
- Printer Sharing
- External Print Server
- Internal Print Server
- Worldwide Sales & Support
- Sales and Support Locations
- Website
6 P330i User’s Manual 980459-001 Rev C Prelim 1
Installation and Setup
Unpacking the Printer
Unpacking the Printer
Your P330i Card Printer ships in a carton and protective anti-static bag. Keep all packaging
material in case you need to move or re-ship the printer.
1. Inspect the shipping container to ensure that no damage has occurred during shipment. If
any damage is apparent, file a claim with the shipper.
2. Unlatch and remove the handles on either end of the shipping container, as shown in the
figure below.
3. (See the figure on the next page as you perform the following steps.) Lift the upper part of
the shipping container off of the lower part (which will still hold the printer and its
packing material).
4. Remove the packing material around the top of the printer.
Electric Shock Caution • Limit AC power supplied to the P330i Printer to 110 ~ 230
volts, 60 ~ 50 Hertz. Limit excess current draw to 16 amps or less, using an associated
circuit breaker or other such device. Never operate the printer in a location where
operator, computer, or printer can get wet. Personal injury could result. The printer must
be connected to an earthed electrical power source and properly protected against
electrical surges and grounding faults; the electrical reliability of the printer is based on
the reliability of the mains power source and with the earth connection.
The printer’s power supply is an internal unit that can only be serviced or replaced by
trained and authorized personnel.
U
P