User's Manual

ManualsBrandsZebra Technologies ManualsPOS EquipmentHands-Free Imager, BT Barcode Scanner

Table Of Contents

Warranty
Patents
Introduction
About this Guide
Unpacking the Imager
Cordless Configuration Features
Corded Configuration Features
- Change Trigger Position
Getting Started - Cordless Configuration
- Before using the Imager, charge the battery. The 8-Bay Battery Charger supports both standard and extended capacity batteries.
- Charge the Battery
- Install the Battery
- Remove the Battery
- Wear the Imager
Getting Started - Corded Configuration
- Connect Corded Adapter
- Remove the Corded Adapter
- Connect to a Wearable Terminal
- Wear the Imager
Status Indications
Bluetooth Connection
- Establish Bluetooth Connection
- Remove Bluetooth Connection
- Restore Lost Bluetooth Connection
Scan
- Scan Triggering Modes
  - Manual Triggering (Triggered models only)
  - Auto-triggering (Triggered models only)
- Aiming the Imager
Customize the Imager Behavior
Troubleshooting
Resetting the Imager
- Warm Boot
- Cold Boot
Field Replaceable Parts
- Comfort Pad Replacement
  - Removal
  - Installation
- Trigger Assembly Replacement
  - Removal
  - Installation
- Fingers Strap Replacement (Trigger Assembly)
  - Removal
  - Installation
- Fingers Strap Replacement (Triggerless Finger Clamp)
  - Removal
  - Installation
- Strap Buckle Replacement
  - Removal
  - Installation
Cleaning
Regulatory Information
- Bluetooth® Wireless Technology
- Wireless Device Country Approvals
Health and Safety Recommendations
- Ergonomic Recommendations
- Warnings for Use of Wireless Devices
  - Potentially Hazardous Atmospheres - Vehicles Use
- Safety in Hospitals
  - Pacemakers
  - Other Medical Devices
- RF Exposure Guidelines
- Laser Devices
  - Imager Labeling
Batteries
- Taiwan - Recycling
  - Battery Information
  - Battery Safety Guidelines
- Radio Frequency Interference Requirements-FCC
  - This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may no...
  - Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
  - Statement of Compliance for Wireless Devices
- Japan (VCCI) - Voluntary Control Council for Interference
  - This is a Class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Eq...
- Korea Warning Statement for Class B ITE
  - Other Countries

20 RS507 Hands-Free Imager

Note: An optional Triggerless Finger Clamp should be installed when the

Imager is intended to be used in Motion and Proximity Initiated Barcode Read

mode.

Fingers Strap Replacement (Trigger Assembly)

Removal

1. Remove the Fingers Strap from the

Strap Buckle.

2. Pull the Fingers Strap out of the

Trigger Assembly.

Installation

1. Align a new Finger Strap with the

Slots in the Trigger Assembly.

2. Gently press the Strap Pins to

engage with the Slots of the Trigger

Assembly. The Strap Pins snap into

the Slots.

3. Slip the Fingers Strap through the

Strap Buckle.

Strap Pins

Slots

Strap Buckle

Fingers Strap

Trigger Assembl

QRG_507.fm Page 20 Wednesday, January 28, 2009 8:37 PM