User's Manual

ManualsBrandsZebra Technologies ManualsPOS EquipmentHands-Free Imager, BT Barcode Scanner

1

2

3

4

5

6

7

8

9

Table Of Contents

Warranty
Patents
Introduction
About this Guide
Unpacking the Imager
Cordless Configuration Features
Corded Configuration Features
- Change Trigger Position
Getting Started - Cordless Configuration
- Before using the Imager, charge the battery. The 8-Bay Battery Charger supports both standard and extended capacity batteries.
- Charge the Battery
- Install the Battery
- Remove the Battery
- Wear the Imager
Getting Started - Corded Configuration
- Connect Corded Adapter
- Remove the Corded Adapter
- Connect to a Wearable Terminal
- Wear the Imager
Status Indications
Bluetooth Connection
- Establish Bluetooth Connection
- Remove Bluetooth Connection
- Restore Lost Bluetooth Connection
Scan
- Scan Triggering Modes
  - Manual Triggering (Triggered models only)
  - Auto-triggering (Triggered models only)
- Aiming the Imager
Customize the Imager Behavior
Troubleshooting
Resetting the Imager
- Warm Boot
- Cold Boot
Field Replaceable Parts
- Comfort Pad Replacement
  - Removal
  - Installation
- Trigger Assembly Replacement
  - Removal
  - Installation
- Fingers Strap Replacement (Trigger Assembly)
  - Removal
  - Installation
- Fingers Strap Replacement (Triggerless Finger Clamp)
  - Removal
  - Installation
- Strap Buckle Replacement
  - Removal
  - Installation
Cleaning
Regulatory Information
- Bluetooth® Wireless Technology
- Wireless Device Country Approvals
Health and Safety Recommendations
- Ergonomic Recommendations
- Warnings for Use of Wireless Devices
  - Potentially Hazardous Atmospheres - Vehicles Use
- Safety in Hospitals
  - Pacemakers
  - Other Medical Devices
- RF Exposure Guidelines
- Laser Devices
  - Imager Labeling
Batteries
- Taiwan - Recycling
  - Battery Information
  - Battery Safety Guidelines
- Radio Frequency Interference Requirements-FCC
  - This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may no...
  - Radio Frequency Interference Requirements - Canada
- Marking and European Economic Area (EEA)
  - Statement of Compliance for Wireless Devices
- Japan (VCCI) - Voluntary Control Council for Interference
  - This is a Class B product based on the standard of the Voluntary Control Council for Interference from Information Technology Eq...
- Korea Warning Statement for Class B ITE
  - Other Countries

6 RS507 Hands-Free Imager

Corded Configuration Features

Release Latch

Imager Window

Fingers Strap

Scan Trigger

Comfort Pad

Corded Adapter

Strap Buckle

Beeper

Restore Key

Left Scan LED

Strap

Right Scan LED

Trigger Assembly

Interface Cable Connector to WT4090

Asset Control Label

QRG_507.fm Page 6 Wednesday, January 28, 2009 8:37 PM