User's Manual
Table Of Contents
- Warranty
- Patents
- Introduction
- About this Guide
- Unpacking the Imager
- Cordless Configuration Features
- Corded Configuration Features
- Getting Started - Cordless Configuration
- Getting Started - Corded Configuration
- Status Indications
- Bluetooth Connection
- Scan
- Customize the Imager Behavior
- Troubleshooting
- Resetting the Imager
- Field Replaceable Parts
- Cleaning
- Regulatory Information
- Health and Safety Recommendations
- Batteries
Quick Reference Guide 7
Change Trigger Position
The Trigger Assembly of the Imager rotates to provide left-hand or right-hand use.
1. Remove the Fingers Strap from the Strap Buckle.
2. From bottom of Imager, Hold and pull the Comfort Pad out of the Barcode
Imager.
3. Determine whether the Imager is used on the right or left hand and rotate the
Trigger Assembly.
4. Rotate the Trigger Assembly so that the Scan Trigger is positioned next to the
thumb when the Imager is placed on the index and middle fingers.
5. Position the Comfort Pad onto the Imager.
6. Press the Comfort Pad onto the Imager. When properly installed, the Comfort
Pad “locks” into place.
7. Insert the Fingers Strap into the Strap Buckle
CAUTION The Trigger Assembly only rotates 180° around the back of the
scan assembly. Do not rotate the Trigger Assembly past the
designed stops
Fingers Strap
Strap Buckle
Comfort Pad
Trigger
Assembly
Trigger Assembly
QRG_507.fm Page 7 Wednesday, January 28, 2009 8:37 PM