User's Manual
Table Of Contents
- Warranty
- Patents
- Introduction
- About this Guide
- Unpacking the Imager
- Cordless Configuration Features
- Corded Configuration Features
- Getting Started - Cordless Configuration
- Getting Started - Corded Configuration
- Status Indications
- Bluetooth Connection
- Scan
- Customize the Imager Behavior
- Troubleshooting
- Resetting the Imager
- Field Replaceable Parts
- Cleaning
- Regulatory Information
- Health and Safety Recommendations
- Batteries
8 RS507 Hands-Free Imager
Getting Started - Cordless Configuration
Before using the Imager, charge the battery. The 8-Bay Battery Charger supports
both standard and extended capacity batteries.
Charge the Battery
To charge the Imager battery, refer to SAC5070 Quick Start Guide.
Install the Battery
1. Align the Battery on top of the Imager.
2. Push the battery all the way into the
Locking Slots of the Imager.
3. Firmly press the Battery into the Imager
until a “click” is heard ensuring the
Battery Release Latch is fully engaged
with the Imager.
Remove the Battery
1. Hold the Imager in one hand.
2. Press the Battery Release Latch.
3. Pull up the Battery to release from the Locking Slots of the Imager.
Wear the Imager
1. Slide the Imager onto the index and middle fingers with the Scan Trigger next
to the thumb.
Locking Slots
Battery
Battery Release
Latch
Scan Trigger
QRG_507.fm Page 8 Wednesday, January 28, 2009 8:37 PM