User's Manual

Introduction The Motorola TW-51x Series Wired/Wireless WallPlate is designed for multi-tenant buildings such as hotels, healthcare facilities, apartments, and dormitory housing. The TW-51x is designed to leverage the in-building telephone wiring to deploy Ethernet and wireless LAN networks without the effort and expense of re-wiring with structured cabling. This installation guide applies to TS-524 (P/N TS-0524-WR), TW-511 (P/N TW-0511-60010-US, -EU, -WR), and TW-510 (P/N TW-0510-WR). Document Conventions The following graphical alerts are used in this document to indicate notable situations:
NOTE Tips, hints, or special requirements that you should take note of. CAUTION Care is required. Disregarding a caution can result in data
loss or equipment malfunction. WARNING! Indicates a condition or procedure that could result in personal injury or equipment damage.
Warnings • This equipment should only be installed by qualified professional installers. • Read all installation instructions and site survey reports, and verify correct equipment
installation before installing this equipment.
• Remove jewelry and watches before installing this equipment. • Verify proper wiring and grounding for each installation location . • Verify there is adequate ventilation around the device, and that ambient temperatures meet
equipment operation specifications (
0° to 40° Celsius / 32° to 104° Fahrenheit).
TS-524 and TW-5xx Specifications * Operating frequencies and transmit power settings depend on national regulatory limits.
Wireless Interface Single radio; 802.11a/b/g/n; 2.4GHz or 5GHz LAN Ethernet port 2 x IEEE 802.3 10/100MB auto-sensing via RJ-45 Uplink UTP 1 x RJ11 UTP, VDSL2 Pass through phone port Filtered RJ11 port Medium DSSS, OFDM, MIMO Standards 802.11a, 802.11b, 802.11g, 802.11n draft 2.0, 802.11i,
802.11-2007
Data rates 802.11b: 1,2,5.5, 11Mbps
802.11g: 6, 9, 12,18, 24, 36, 48, 54Mbps 802.11a: 6, 9, 12,18, 24, 36, 48, 54Mbps 802.11n: MCS 0 to 15 up to 300Mbps
Operating frequencies
*
2.4GHz: 2400 to 2483.5MHz 5GHz: 5150 to 5250MHz, 5725 to 5850MHz
Transmit power settings
*
1dBm to 20dBm, in 1dBm increments
Antenna configuration Two internal omni-directional, 1x2 or 2x2 MIMO operation
3dBi peak @ 2.4GHz
VLANs 802.1 Q tagged VLANS, access or trunk TS-524 management Telnet, SSH, HTTPS, Serial Console TS-524 uplink ports 2 x IEEE 802.3 10/100/1000MB auto-sensing RJ-45 TS-524 UTP ports 1 x RJ21 for PBX connection, 1 x RJ21 for downstream VDSL2
MOTOROLA SOLUTIONS INC. 1303 E. ALGONQUIN ROAD SCHAUMBURG, IL 60196 http://www.motorolasolutions.com
TS-524 Switch and TW-5xx WallPlate
Installation Guide
MN000030A01 July 2013 Revision A
(2)
(1)
(3) (4) (5) (6)
Installing In-line Filters The TW-5x Wallplate features a built-in Plain Old Telephone Setvice (POTS) and Line Power filter for the desk phone. Install an in-line filter on all other phone jacks that will have a phone connected. The terminated filter has a clipped RJ11 connector. This is purposely done to comply with EN60950 requirements. Use a small flat blade screwdriver to lift the tab if attempting to remove the filter. If installing a filter on a bathroom phone, use the unterminated filter. Remove the bathroom wall plate and terminate the filter in the wall box using wire beans.
Installing the TW-51x WallPlate
1. Loosen the screws on the existing wall plate to create a gap of 6mm (1/4 in). 2. Attach the mounting adapter using the keyhole slots. 3. Tighten the screws until the mounting adapter is securely attached.
CAUTION Do not over tighten.
4. Connect the supplied 10cm cable between the TW-51x bottom mounted RJ11
jack and the existing RJ11 jack.
5. Hook the bottom tabs on the mounting adapter to the TW-51x. Rotate and
snap the TW-51x onto the adapter.
Network Configuration (TS-524) The following will enable all ports and configure one wireless LAN: Log in to the system using Telnet, SSH, HTTP, or Serial Console using the default username and password: Username: admin Password: motorola Enter the following commands: config password admin <enter your new password> country-code <xx = your country> hostname <enter your hostname> interface vlan1 ip-address 192.168.1.1/24 wlan Guest exit int dsl1-24 no shutdown int radio1-24.1 channel 6 power 18 wlan Guest no shutdown exit
Enabling Line Power Line power should be enabled after the filters and TW-51x WallPlate have been installed. Line power is safe for use with telephony equipment but it will ring the phones if the filters are not installed first. To enable line power, enter the following commands into the CLI: interface dsl1-24 line-power write memory Regulatory Information This device is approved under Motorola Solutions, Inc. This guide applies to Model Numbers: TS-524, TW-510, and TW-511. All Motorola devices are designed to be compliant with rules and regulations in locations where they are sold and will be labeled as required. Local language translations are available at the following website: http://www.motorolasolutions.com/support
.
Any changes or modifications to Motorola Solutions equipment, not expressly approved by Motorola Solutions, could void the user's authority to operate the equipment. When Motorola Solutions devices are professionally installed, the Radio Frequency Output Power will not exceed the maximum allowable limit for the country of operation. Antennas: Use only the supplied or an approved replacement antenna. Unauthorized antennas, modifications, or attachments could cause damage and may violate regulations. Radio Modules The TW-511 contains an approved radio module. This module is identified below: Motorola Solutions, Inc. 802.11 a/b/g/n WLAN, Type: TW-5 Wireless Device Country Approvals (TW-511 only) Regulatory markings, subject to certification, are applied to the device signifying the radio(s) is/are approved for use in the following countries: United States, Canada, Japan, China, S. Korea, Australia, and Europe. Please refer to the Declaration of Conformity (DoC) for details of other country markings. This is available at http://www.motorolasolutions.com/doc
.
Note: Europe includes, Austria, Belgium, Bulgaria, Czech Republic, Cyprus, Denmark, Estonia, Finland, France, Germany, Greece, Hungary, Iceland, Ireland, Italy, Latvia, Liechtenstein, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania, Slovak Republic, Slovenia, Spain, Sweden, Switzerland and the United Kingdom.
Serial Console Connection Default IP Address Speed: 19200 Data Bits: 8 Parity: None Stop Bit: 1 Flow Control: None
192.168.1.3