User's Manual

4 - 2 MPact Location & Analytics Hardware Installation Guide
Figure 4-1 shows a beacon with the mylar strip attached to the left-hand side of the housing.
Figure 4-1 Tie Wrap Style Beacon - Part Number - MPACT-T1B20-000-WR
When installing numerous beacons, group beacons by category configurations and activate the beacons prior to scanning the
barcodes and associating them with positions in the Toolbox.
2. After pulling off the last mylar strip for the group of deployment beacons, you have 20 seconds to associate the beacon in
either offlin
e or online mode in the Toolbox application.
3. From MPact Toolbox, select a site floor plan and an unassigned position for the beacon. Refer to the MPact Location &
Analytics Deployment Guide for information on how to install and deploy the beacon from the Toolbox.
To mount the tie wrap beacon to a pole or similar structure:
1. Mount the beacon to a pole or similar structure using the plastic tie wrap
. Tie can be placed vertically or horizotally but the
arrow should still point up.
4.2 Beacon Part Number: MPACT-T1B10-000-WR
As a prerequisite, the following hardware items are required to mount beacon brackets to a Lozier style shelf:
• Lozier® Shelves
• Beacon: Part number - MPACT-T1B10-000-WR
• When ordering, use the following part number: MPACT-T1B10-250-WR (Box of 25)
• Bracket mount, one of the following:
• MPACT Metal Lozier Bracket: Part number MPACT-A1O10-004-WR
• MPACT Plastic Lozier Bracket: Part number MPACT-A1O10-001-WR
• Phillips head screw driver for mounting the bracket (metal brack
ets only) to the Lozier shelf
4.2.1 Installing the Universal Style Beacon
Figure 4-2 shows a universal style beacon. While there is no up arrow on this beacon’s housing, the beacon should be oriented
similar to the tie wrap style of beacon housing, see Beacon Part Number: MPACT-T1B20-000-WR.
Notice the up arrow located on the middle of the beacon housing. This a
rrow indicates the optimal orientation for the beacon
to function properly. Additionally, the smooth front of the beacon should face outward toward the aisle where client devices
are expected to engage (dwell).
To activate a beacon part number - MPACT-T1B10-000-WR:
1. Activate one or more beacons by pulling the mylar strip off the beacon housing.
Draft