User's Manual

Beacon Hardware Specifications and Installation 4 - 3
Figure 4-2 shows a beacon with the mylar strip attached to the left-hand side of the housing.
Figure 4-2 Universal Style Beacon - Part Number - MPACT-T1B10-000-WR
When installing numerous beacons, group beacons by category configurations and activate the beacons prior to scanning the
barcodes and associating them with positions in the Toolbox.
2. After pulling off the last mylar strip for the group of deployment beacons, you have 20 seconds to associate the beacon in
either offlin
e or online mode in the Toolbox application.
3. From MPact Toolbox, select a site floor plan and an unassigned position for the beacon. Refer to the MPact Location &
Analytics Deployment Guide for information on how to install and deploy the beacon from the Toolbox.
To mount the universal style beacon to Lozier® Shelves:
1. Mount the universal beacon shelf-bracket on the shelf:
• Met
albrackets: Fit in place and tighten onto the shelving unit using a phillips-head screw driver.
• Plastic brack
ets: Fit in place and snap onto the shelving unit.
3. Fit the beacon’s universal style housing into the bracket (mylar tap pointing
up) and turn the beacon housing clockwise 90
degrees.
Draft