User's Manual

Beacon Hardware Specifications and Installation 4 - 5
• Bracket mount kit see Figure 4-6 (included with part number MPACT-MB2000-01-WR):
• Metal bracket
• Two 1inch Phillips head tap screw, and two 1inch plastic wall inserts
• Phillips head screw driver for mounting the b
racket (metal brackets only) to a wall
4.3.1 Installing the Indoor Style Beacon
To activate a beacon part number - MPACT-MB2000-01-WR:
1. Activate one or more beacons by pulling the mylar strip out from inside the beacon housing.
Figure 4-5 shows the back of a Indoo
r style beacon.
Figure 4-5 Indoor Style Beacon - MPACT-MB3000-01-WR
When installing numerous beacons, group beacons by category configurations and activate the beacons prior to scanning the
barcodes and associating them with positions in the Toolbox.
2. After pulling off the last mylar strip for the group of deployment beacons, you have 20 seconds to associate the beacon in
either offlin
e or online mode in the Toolbox application.
3. From MPact Toolbox, select a site floor plan and an unassigned position for the beacon. Refer to the MPact Location &
Analytics Deployment Guide for information on how to install and deploy the beacon from the Toolbox.
To mount the universal style beacon to a wall:
1. From MPact Toolbox, select a site floor plan and an unassigned position for the beacon.
2. Mount the Indoor Metal beacon wall bracket on the wall with
the provided screws and plastic wall inserts:
• Bra
cket mount kit:
Draft