User's Manual

Beacon Hardware Specifications and Installation 4 - 9
Figure 4-8 Beacon Battery Housing Example: MPACT-T1B20-000-WR and MPACT-T1B20-000-WR and MPACT-T1B10-000-WR
3. With both tray corners dislodged, gently slide the battery tray open, being careful not to drop the tray.
Figure 4-9 shows an open battery housing. In this example, the battery tray is a separate piece, along with the battery, on
the right-hand side.
Figure 4-9 Battery Tray: MPACT-T1B20-000-WR and MPACT-T1B20-000-WR and MPACT-T1B10-000-WR
4. Remove the old battery and dispose of properly and replace it with a new battery (Panasonic CR2450)
5. Close the tray, ensuring the latch is secure.
4.5.2 Replacing Battery: MPACT-MB2000-01-WR
To replace a beacon’s battery in part number MPACT-MB2000-01-WR:
1. Remove the beacon from the shelving unit (see information on the appropriate beacon part number).
2. With the bottom of the beacon facing up, use your finger nail to gently lift the clip up to remove the back off the beacon’s
battery enclosure.
3. Remove the old batteries and dispose of properly and replace it with two new 2AA batteries.
Figure 4-10 shows an open battery enclosure of Indoor Style Beacon.
NOTE: Pay attention to the position of the + on the battery. Installing the battery
backwards may damage the Beacon
NOTE: Pay attention to the polarity (+ and -) of the batteries. Installing the batteries
incorrectly may damage the Beacon
Draft