Datasheet

Replacement Procedures
Main PCBA
980006-001 Rev. A Zebra P630i & P640i Card Printer Service Manual 169
f. Tighten the payout spindle nut until the O-ring bows, then back off slightly.
g. Listen to the “hum” of the motor.
h. Adjust the tightness of the payout spindle nut until the motor hum is constant.
i. This test takes approximately ten minutes. When the motor stops turning, go to
the next step.
Step 4. Adjust Payout Clutch
a. From the IDPrint screen, select Control > Ribbon Tasks > Adjust Payout Clutch:
Note • You may need to repeat this step until you are satisfied with the adjustment.