Datasheet

230 Zebra P630i & P640i Card Printer Service Manual 980006-001 Rev. A
Replacement Procedures
Ribbon Payout Spindle
b. Observe the two cores rotate counterclockwise.
c. Observe the panel lights.
d. Adjust the payout spindle nut as required -- if Red, tighten; if Green, loosen.
e. When the motor stops turning and you are satisfied with the adjustment, go to the
next step.
Step 5. Remove the O-ring and the two Grooved Splined Cores.
Step 6. Load the Ribbon.
Step 7. Power Cycle the Printer.
Note • The panel lights should flash an equal amount of time between Green (Ready) and
Red (Alarm) -- the optimum condition would be Yellow (Media) on all the time.