User guide

Print Quality Problems
108
57512L-004 110PAX4/R110PAX4 User Guide 6/29/11
Print Quality Problems
Table 11 identifies problems with print quality, the possible causes, and the recommended
solutions.
Table 11 • Print Quality Problems
Problem Possible Cause Recommended Solution
General print quality
issues
The print engine is set at the
incorrect print speed.
For optimal print quality, set the print speed to
the lowest possible setting for your application
via control panel, the driver, or the software. See
Adjust Print Speed on page 64. You may want to
perform the FEED Self Test on page 122.
You are using an incorrect
combination of labels and
ribbon for your application.
1. Switch to a different type of media or ribbon
to try to find a compatible combination.
2. If necessary, consult your authorized Zebra
reseller or distributor for information and
advice.
The print engine is set at an
incorrect darkness level.
For optimal print quality, set the darkness to the
lowest possible setting for your application via
the control panel, the driver, or the software. See
Adjust Print Darkness on page 64. You may
want to perform the FEED Self Test on page 122
to determine the ideal darkness setting.
The printhead is dirty. Clean the printhead. See Clean the Printhead
and Platen Roller on page 93.
Incorrect or uneven printhead
pressure.
Set the printhead pressure to the minimum
needed for good print quality. See Printhead
Pressure Adjustment on page 97.
The printhead is improperly
balanced.
Call a service technician.
Long tracks of
missing print on
several labels
Print element damaged. Call a service technician.
Wrinkled ribbon. See wrinkled ribbon causes and solutions in this
table.