User guide

Configuration
Control Panel Parameters
86
57512L-004 Rev. A 110PAX4/R110PAX4 User Guide 6/29/11
Set Ribbon Low Mode
When the Ribbon Low feature is off, the output signal (Pin 9) does not
function, the LOW RIBBON warning is not displayed, and the print engine
continues to print until it runs out of ribbon.
When the Ribbon Low feature is set to any of the lengths, output signal
(Pin 9) on the applicator port is functional. When the amount of ribbon on
the supply spindle reaches the specific length, the output signal asserts to
provide a
RIBBON LOW warning. For print engines with the RIBBON
LOW OUTPUT
parameter, set the output signal to assert HIGH or LOW.
For print engines without this parameter, the signal asserts HIGH.
Default: 25M
Selections: OFF, 25M, 50M, 75M, 100M
To change the value shown:
1. Press the left or right oval to scroll through the options.
Set Ribbon Low Output
Note • This parameter is not available on older 110PAX4 firmware
and will be added to a future release of the R110PAX4. Check for
the latest firmware at http://www.zebra.com/firmware.
When the Ribbon Low feature is on, this parameter determines if the output
signal on Pin 9 is HIGH or LOW.
Default: ACTIVE HIGH
Selections: ACTIVE HIGH, ACTIVE LOW
Set Reprint Mode
When the Reprint feature is enabled, the reprint input signal (Pin 6) on the
applicator port is functional. When the input signal is asserted, the last label
printed is printed again. (This includes non-printing labels.) When the
Reprint feature is disabled, the reprint input signal is ignored.
Note • The ^SP ZPL command is ignored when the Reprint feature
is enabled. When the Reprint feature is disabled, the
^SP command
can be used. In addition, when a received label format is canceled
prior to printing, the reprint function for the previous label is also
canceled. Refer to the ZPL II Programming Guide for additional
information.
Default: DISABLED
Range: ENABLED, DISABLED
To change the value shown:
1. Press the left or right oval to toggle between the options.
Table 7 • Print Engine Parameters (Page 23 of 25)
Parameter
Action/Explanation
RIBBON LOW MODE
- 25M +
RIB LOW OUTPUT
- ACTIVE HIGH +
REPRINT MODE
- DISABLED +