User's Manual
Manuals
Brands
Zebra Manuals
All in One Printer
Zebra 22380100000
61
62
63
64
65
66
67
68
69
70
Table Of Contents
Declaration of Conformity
Compliance Information
Contents
About This Document
Who Should Use This Document
How This Document Is Organized
Contacts
Document Conventions
Introduction
Printer Components
Control Panel
Printer Setup
Before You Begin
Handling the Printer
Unpack and Inspect the Printer
Store the Printer
Ship the Printer
Select a Site for the Printer
Select a Surface
Provide Proper Operating Conditions
Allow Proper Space
Provide a Data Source
Provide a Power Source
Select a Data Communication Interface
Data Cables and Wireless Cards
Connect the Printer to a Power Source
Power Cord Specifications
Install the Control Panel Keypad Cover
Types of Media
Ribbon Overview
When to Use Ribbon
Coated Side of Ribbon
Operations
Print Modes and Printer Options
Print Mode Descriptions and Printer Requirements
Media Paths
Prepare the Media for Loading
Load Media in Tear-Off Mode
Load Media in Peel-Off Mode
Load Media in Cutter Mode
Load Media in Rewind Mode
Remove Media Liner from the Rewind Spindle
Load Ribbon
Remove Used Ribbon
Calibrate the Printer
Adjust Transmissive Media Sensors
Upper Media Sensor
Lower Media Sensor
Adjust Printhead Pressure and Toggle Position
Toggle Position Adjustment
Printhead Pressure Adjustment
Configuration
Setup Mode
Enter and Use Setup Mode
Exit Setup Mode
Change Password-Protected Parameters
Default Password Value
Disable the Password Protection Feature
Print a Configuration Label
Print a Network Configuration Label
Standard Control Panel Parameters
Additional Control Panel Parameters
Routine Maintenance
Replacing Printer Components
Ordering Replacement Parts
Recycling Printer Components
Lubrication
Cleaning Schedule and Procedures
Clean the Exterior
Clean the Media Compartment
Clean the Printhead and Platen Roller
Clean the Sensors
Clean the Snap Plate
Clean the Cutter
Replace the Fuse
Troubleshooting
Troubleshooting Checklists
LCD Error Messages
Print Quality Problems
Calibration Problems
Communications Problems
Ribbon Problems
RFID Problems
Miscellaneous Printer Problems
Printer Diagnostics
Power-On Self Test
CANCEL Self Test
PAUSE Self Test
FEED Self Test
FEED and PAUSE Self Test
Communications Diagnostics Test
Sensor Profile
Specifications
Features
Standard Features
Optional Features
Zebra Programming Language (ZPL)
Bar Codes
General Specifications
Physical Specifications
Electrical Specifications
Environmental Conditions for Operation and Storage
Print Specifications by Model
110Xi4 and R110Xi4
140Xi4, 170Xi4, and 220Xi4
Ribbon Specifications
110Xi4 and R110Xi4
140Xi4, 170Xi4, and 220Xi4
Media Specifications
110Xi4 and R110Xi4
140Xi4, 170Xi4, and 220Xi4 Printers
End User License Agreement
Glossary
Index
Operations
Load Media in Rewind Mode
68
P1009874-002
Xi4™/RXi4™ User Guide
1/7/10
2.
Pull out the spindle ho
ok.
3.
Slide the media or l
iner off o
f the rewind spindle.
1
...
...
66
67
68
69
70
...
...
190
