Specifications

Set Media Sensors
The ^SS (Set Media Sensor) instruction is used to change the values
for media, web, ribbon and label length that were set during the
“media calibration” process. The “Media Calibration” process is
described in your specific printer’s user’s guide.
In the illustration below is an example of a Media Sensor Pro-
file. Notice the numbers from 000 to 100 and where the words
WEB, MEDIA and RIBBON appear in relation to those numbers.
Also notice the black vertical spike. This represents where the
printer sensed the transition from media-to-web-to-media.
NOTE: Media and Sensor Profile produced on your printer may
look different than the one shown here.
322 ZPL II COMMAND REFERENCE
^SS