Reference Guide

Radio Communications
82
Page Options
To select a page option, select one of the barcodes below.
Page Mode
Parameter # 1364 (SSI # F8h 05h 54h)
• Page State - In this mode, the cradle sends a page state request to each scanner. It remains in Page
State indication until every scanner sends an acknowledgment.
The scanner enters Page State when the LED indicator is blinking blue and the vibrator and beeper
is activated. When the trigger is pressed, or the scanner is inserted into the cradle, or the requested
timeout (default is 30 sec) is reached, the scanner sends the acknowledgment to the cradle and
returns to its normal state.
• Page Simple - In this mode, the cradle sends a page indication request to each scanner, and returns
to idle state. Each scanner issues a single Page State indication.
Page State Timeout
Parameter # 1365 (SSI # F8h 05h 55h)
Page timeout is programmable in 1 second increments from 1 to 99 seconds. The default timeout is 30
seconds.
To set a page timeout:
1. Scan the Page Timeout barcode below.
2. Scan two numeric barcodes from <bl_blue><em_Emphasis>Numeric Barcodes on page G-1 that
correspond to the desired timeout duration. Enter a leading zero for single digit numbers (for example,
for a 5 second page timeout, scan the 0 barcode and then the 5 barcode). To correct an error or
change the selection, scan <bl_blue><em_Emphasis>Cancel on page H-1.
The Page State Timeout default is 30 seconds.
Page State
*Page Simple
note Page State Timeout only applies to Page State Mode.
guide-user-color-8.5x11.book Page 82 Monday, June 1, 2020 5:43 PM
Draft v 10