Reference Guide

87
User Preferences
Introduction
You can program the digital scanner to perform various functions, or activate different features. This
chapter describes each user preference feature and provides programming barcodes for selecting these
features.
The digital scanner ships with the settings shown in <em_Emphasis><bl_blue>Table 10-6 on page 10-88
(also see <em_Emphasis><bl_blue>Appendix A, Standard Parameter Defaults for all defaults). If the
default values suit requirements, programming is not necessary.
To set feature values, scan a single barcode or a short barcode sequence. The settings are stored in
non-volatile memory and are preserved even when the digital scanner is powered down.
If not using a USB cable, select a host type (see each host chapter for specific host information) after the
power-up beeps sound. This is only necessary upon the first power-up when connected to a new host.
To return all features to default values, see <bl_blue><em_Emphasis>Default Parameters on page 10-95.
Throughout the programming barcode menus, asterisks indicate (
*) default values.
note Most computer monitors allow scanning the barcodes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the barcode clearly, and
bars and/or spaces are not merging.
*High Volume
(0)
Feature/Option
* Indicates Default
Option Value
guide-user-color-8.5x11.book Page 87 Monday, June 1, 2020 5:43 PM
Draft v 10