Reference Guide

User Preferences
123
Timeout Between Decodes, Same Symbol
Parameter # 137 (SSI # 89h)
Use this option in Continuous Barcode Read mode to prevent the beeper from continuously beeping when
a symbol is left in the digital scanner field of view. The barcode must be out of the field of view for the
timeout period before the digital scanner reads the same consecutive symbol. It is programmable in 0.1
second increments from 0.0 to 9.9 seconds. The default interval is 0.5 seconds.
To select the timeout between decodes for the same symbol, scan the barcode below, then scan two
numeric barcodes from <em_Emphasis><bl_blue>Appendix G, Numeric Barcodes that correspond to the
desired interval, in 0.1 second increments.
Timeout Between Decodes, Same Symbol
Timeout Between Decodes, Different Symbols
Parameter # 144 (SSI # 90h)
Use this option in presentation mode or Continuous Barcode Read to control the time the digital scanner is
inactive between decoding different symbols. It is programmable in 0.1 second increments from 0.1 to 9.9
seconds. The default is 0.1 seconds.
To select the timeout between decodes for different symbols, scan the barcode below, then scan two
numeric barcodes from <em_Emphasis><bl_blue>Appendix G, Numeric Barcodes that correspond to the
desired interval, in 0.1 second increments.
Timeout Between Decodes, Different Symbols
note Timeout Between Decodes, Different Symbols cannot be greater than or equal to the Decode Session
Timeout.
guide-user-color-8.5x11.book Page 123 Monday, June 1, 2020 5:43 PM
Draft v 10