Reference Guide

SSI Interface
191
Simple Serial Interface Default Parameters
This section describes how to set up the digital scanner with an SSI host. When using SSI, program the
digital scanner via barcode menu or SSI hosts commands.
Throughout the programming barcode menus, asterisks (
*) indicate default values.
<em_Emphasis><bl_blue>Table 13-12 lists the defaults for the SSI host. There are two ways to change
the default values:
• Scan the appropriate barcodes in this guide. These new values replace the standard default values
in memory. To recall the default parameter values, scan the <bl_blue><em_Emphasis>*Restore
Defaults barcode on<em_Emphasis><bl_blue> page 6-5.
• Download data through the device serial port using SSI. Hexadecimal parameter numbers appear in
this chapter below the parameter title, and options appear in parenthesis beneath the accompanying
barcodes. Refer to the Simple Serial Interface (SSI) Programmer’s Guide for detailed instructions for
changing parameters using this method.
*Baud Rate 9600
(6)
Feature/Option
* Indicates Default
Option value for programming
note Most computer monitors allow scanning the barcodes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the barcode clearly, and
bars and/or spaces are not merging.
note See <em_Emphasis><bl_blue>Appendix A, Standard Parameter Defaults for all user preferences, hosts,
symbologies, and miscellaneous default parameters.
Table 13-12 SSI Default Table
Parameter
Parameter
Number
SSI
Number
Default
Page
Number
Select SSI Host N/A N/A N/A <em_Emp
hasis><bl_
blue>13-1
92
Software Handshaking 159 9Fh ACK/NAK <em_Emp
hasis><bl_
blue>13-1
94
Decode Data Packet Format 238 EEh Send Raw Decode Data <em_Emp
hasis><bl_
blue>13-1
94
guide-user-color-8.5x11.book Page 191 Monday, June 1, 2020 5:43 PM
Draft v 10