Reference Guide

Maintenance, Troubleshooting, and Technical Specifications
32
Digital scanner
emits
low/high beeps during
programming.
Input error, incorrect barcode or
Cancel barcode was scanned.
Scan the correct numeric barcodes within
range for the parameter programmed.
Digital scanner emits
low/high/low/high beeps
during programming.
Out of host parameter storage
space.
Scan <bl_blue><em_Emphasis>Default
Parameters on page 6-5.
Out of memory for ADF rules. Reduce the number of ADF rules or the
number of steps in the ADF rules.
During programming, indicates out
of ADF parameter storage space.
Erase all rules and re-program with shorter
rules.
Digital scanner emits
low/high/low beeps.
ADF transmit error. Refer to the Advanced Data Formatting Guide
for information.
Invalid ADF rule is detected. Refer to the Advanced Data Formatting Guide
for information.
Digital scanner emits a
power-up beep after
changing USB host type.
The USB bus re-established power
to the digital scanner.
Normal when changing USB host type.
Digital scanner emits one
high beep when not in use.
Digital scanner emits
frequent beeps.
No power to the scanner. Check the system power. If the configuration
requires a power supply, re-connect the power
supply.
Incorrect host interface cable is
used.
Verify that the correct host interface cable is
used. If not, connect the correct host interface
cable.
Interface/power cables are loose. Check for loose cable connections and
re-connect cables.
Table 8-1 Troubleshooting (Continued)
Problem Possible Causes Possible Solutions
guide-user-color-8.5x11.book Page 32 Monday, June 1, 2020 5:43 PM
Draft v 10