Reference Guide

Maintenance, Troubleshooting, and Technical Specifications
33
Dump Scanner Parameters
To debug a scanner issue, scan the following barcode with the scanner connected in USB HID keyboard
mode to Microsoft
®
Windows Notepad or Wordpad. This outputs all the scanner's asset tracking
information and parameter settings to a text document.
See the parameter numbers in <em_Emphasis><bl_blue>Appendix A, Standard Parameter Defaults to
interpret the parameter/attribute numbers in the output.
Digital scanner emits five
long low beeps after a
barcode is decoded.
Conversion or format error was
detected.
The scanner conversion
parameters are not properly
configured.
Ensure the scanner conversion parameters
are properly configured.
Conversion or format error was
detected.
An ADF rule was set up with
characters that can't be sent for the
host selected.
Change the ADF rule, or change to a host that
can support the ADF rule.
Conversion or format error was
detected.
A barcode was scanned with
characters that can't be sent for
that host.
Change the barcode, or change to a host that
can support the barcode.
Digital scanner LED blinks
even if the pairing request
was canceled from remote
iOS/Android
™ device.
If pass key entry is canceled from
the tablet/phone, the digital
scanner remains in the pass key
entry mode for 30 seconds before
timing out.
To exit pass key entry mode scan
<bl_blue><em_Emphasis>Cancel on page
H-1 or scan any other barcode.
Table 8-1 Troubleshooting (Continued)
Problem Possible Causes Possible Solutions
note If after performing these checks the digital scanner still experiences problems, contact the distributor or
call support.
note Use 123Scan if available as an alternative to using this feature. 123Scan is the preferable method for
outputting scanner information.
note For proper formatting, it may be necessary to first scan <bl_blue><em_Emphasis><DATA> <SUFFIX 1>
(1) on page 6-40.
Dump Scanner Parameters
guide-user-color-8.5x11.book Page 33 Monday, June 1, 2020 5:43 PM
Draft v 10