Reference Guide

Radio Communications
73
Pairing Methods
Parameter # 545 (SSI # F1h 21h)
There are two pairing methods. The default method allows the digital scanner and cradle to pair (connect)
when the pairing barcode on the cradle is scanned. A second method pairs the digital scanner and cradle
when the digital scanner is inserted in the cradle. To enable this feature, scan Enable Pair On Contacts
below. With this feature enabled it is not necessary to scan the pairing barcode on the cradle. If the pairing
is successful, a low/high connection beep sequence sounds a few seconds after the digital scanner is
placed in the cradle. See <bl_blue><em_Emphasis>Wireless Beeper Definitions on page 9-46 for other
beep sequences.
To enable or disable pairing on contacts, scan the appropriate barcode below.
Press Trigger Twice to Re-connect
Upon a double trigger press, the scanner attempts to connect to the last known address. This feature
differs from auto-reconnect (see <bl_blue><em_Emphasis>Auto-Reconnect Feature on page 9-64) in that
the scanner attempts connection only once and keeps the address even on commanded disconnect. The
last known address is only cleared upon a reject or with a new successful connection. The address
persists over scanner reboot.
*Enable Pair On Contacts
(1)
Disable Pair on Contacts
(0)
important This feature only applies to hosts capable of a commanded connection; SPP slave and HID BLE
hosts do not support this feature.
note This feature does not interfere with a double trigger press to open/close an iOS keypad in HID mode.
guide-user-color-8.5x11.book Page 73 Monday, June 1, 2020 5:43 PM
Draft v 10