Quick Start Guide

ET5X
Expansion Back
Installation Guide
Installation
Regulatory
This guide applies to the following Model Numbers: ZBK-ET5X-10RH1, ZBK-
ET5X-10SCN, ZBK-ET5X-8RH1 and ZBK-ET5X-8SCN.
All Zebra devices are designed to be compliant with rules and regulations in
locations they are sold and will be labeled as required.
Local language translations are available at the following website: http://
www.zebra.com/support.
Any changes or modifications to Zebra equipment, not expressly approved by
Zebra, could void the user's authority to operate the equipment.
For use only with Zebra approved and UL Listed mobile computers, Zebra
approved, and UL Listed/Recognized battery packs.
Health and Safety Recommendations
Ergonomic Recommendations
• Reduce or eliminate repetitive motion
• Maintain a neutral postures
• Reduce or eliminate excessive force
• Keep objects that are used frequently within easy reach
• Perform tasks at correct heights
• Reduce or eliminate vibration
• Reduce or eliminate direct pressure
• Provide adjustable workstations
• Provide adequate clearance
• Provide a suitable working environment
• Improve work procedures
Laser Devices
Class 2 laser scanners use a low power, visible light diode. As with any very
bright light source such as the sun, the user should avoid staring directly into
the light beam. Momentary exposure to a Class 2 laser is not known to be
harmful.
The following statement is required to comply with US and international
regulations.
1
CAUTION: Power off the ET5X before installing or
removing Expansion Back.
2
Remove battery cover and store in safe place.
Rubber Gasket
3
On 8” version only, remove rubber gasket.
4
8” Configuration
Align expansion back with device. Ensure that the power
pack slot cover is aligned with the bottom of the device and
the interface connector on expansion back aligns with
interface connector on device.
Interface
Connector
Power Pack Slot
Cover
10”
Configuration
Interface
Connector
Power Pack Slot
Cover
5
Screws (4)
Using a T6 Torx screwdriver, secure expansion back to
device using four screws. Torque to 14 n-cm.
CAUTION In order to avoid or minimize the potential risk of
ergonomic injury follow the recommendations below.
Consult with your local Health & Safety Manager to
ensure that you are adhering to your company’s safety
programs to prevent employee injury.
CAUTION Use of controls, adjustments, or the performance of
procedures other than those specified herein may result
in hazardous laser light exposure.